The BIOS password in Dell laptops is stored with the help of the CMOS battery, which is located on the motherboard. No two systems are alike and the location of the CMOS battery is often difficult to get to on laptops for security reasons.

Once located, removal of the battery for a period of time will always reset the BIOS settings to factory default. This erases the password as well as the date and time and resets various other BIOS settings as well. This is normally all that is required to boot to the operating system.

For different needle PSWD, the way to clear BIOS password is different. One: When PSWD is Two Needle Find out PSWD, and remove power line until main board led turn off. Lsi Embedded Megaraid Windows 7. Remove jumper cap on PSWD, start Dell computer and you will hear the sound of drop. And BIOS password is removed or cleared. Dainik Jagran Muzaffarpur Edition. Compile Run Cobol Program Windows Xp.

Finding the CMOS Battery Remove the power cord and main system battery from the laptop. Remove the hard drive. Check the area for the coin cell battery in the hard drive compartment and in each subsequent step until it is located, and then skip to the battery removal section. Remove the cover that contains the system RAM. Remove the optical drive if it is accessible at this stage. Remove all other removable devices such as USB or Cardbus adapters.

Remove the screws from the bottom of the laptop and from the back of the laptop and begin to disassemble the laptop, taking care to track where each piece goes and which screws go in which holes. Remove the keyboard and the touchpad if necessary. Disconnect the small ribbon cables and other cables carefully and note where they go and how they connect. Remove the motherboard from the laptop and inspect both sides for the location of the battery. Removing the Battery Remove the CMOS battery once it is located and allow the system to remain idle for one hour to ensure the BIOS password has a chance to clear. Insert the battery back onto the motherboard and reinstall any pieces that were removed. Boot the computer and follow the prompts to set the date and time and to save settings.

No password will be required to boot the computer to the operating system. Supply the password to log onto Windows.